Foxcom SATLIGHT 7225H, Installation And User Manual

Page: 21 / 60

Connecting the Back Panel Jumpers
7225H Interfacility Link Installation and User’s Guide page 13
Foxcom proprietary information
2.5 Connecting the Back Panel Jumpers
On the rear panel of the 7180M Back Panel are product selectors (JP1 to JP4). The 3 pin selectors (male) are
the connecting point between the slots and the back panel. One pin is for the transmitter/receiver (Tx/Rx), one
is for the optional 2040 1:1 Redundant Switch, and one is for the 7180M. A 2 pin jumper (female) is placed on
the relevant pins to complete the connection between the 7180M and the units. For example, if a 2040 Switch
is being used, the jumper is placed on the Switch-7180M pins.
To connect the jumpers:
1. Each jumper has two sets of pins, upper and lower. The upper pins are labeled SW (Switch) and the lower
pins Tx/Rx.
2. If the 7180M has Tx or Rx units only, place all jumpers on the lower two pins.
Figure 8 Jumper Installation: Tx and Rx only
3. If the 2040 Switch is installed in Slot 2, place the JP1 and JP2 jumpers on the higher two pins and the JP3
and JP4 jumpers on the lower two pins.
Figure 9 Jumper Installation: 2040 Switch in slot 2