Chapter 1
DaqPRO
11
1.2.2. Quick-Start
Before you first use
DaqPRO
, charge the unit for 10 to 12 hours while it is turned off.
1. Turn on
DaqPRO
Press the
On
button. You will see the initialization screen.
DaqPRO
performs a brief self-check and
displays its status, including operating mode. It then loads the last setup you used (refer to page 20). If
you need a new setup wait until you see the Main Menu screen:
fn
?
2. Connect the Sensors
Start with the first input on the right.
Note:
Sensors must be added successively, starting with input 1. If a single sensor is used it must be
connected to Input
1. If two sensors are used, they must be connected to Input
1 and Input
2.
Refer to
Sensors Types and Connections
on page 5 for more details.
3. Identify the Sensors
You must tell
DaqPRO
what type of sensor is connected to each input.
a. In the Main Menu screen, use the
Forward
arrow
buttons to select the
setup
menu icon
.
www.esis.com.au
Ph 02 9481 7420
Fax 02 9481 7267
