Four winns 358 VISTA, Owner'S Manual

Page: 81 / 257

Owner’s Manual Page 78 Electrical Systems - Section H
Horn - To sound the horn, press the HORN switch.
Navigation & Anchor Lights - Moving the NAV/ANC
LTS switch towards the NAV position activates the
bow lights, the all-around light and the instru ment
lights on the dash. Move the switch to the ANC
posi tion to activate the all-around light. The center
switch posi tion is “OFF”.
Arch Lights - The ARCH LIGHTS switch is used to
activate the radar arch lights.
Platform Lights - The PLATFORM LIGHTS switch is
used to activate the lights for the swim platform.
Engine Lights - The ENGINE LIGHTS switch is used
to activate the engine lights in the engine compart-
ment.
Seat Switch- Activating the “SEAT” switch on the
starboard dash panel allows the driver to move his
seat forward or aft to the desired position.
Trim Tabs - The boat is equipped with electric -
hyd raulic trim tabs, the trim tabs are controlled by the
TRIM TAB switches. Re fer to Section E-8 - Trim Tabs
for more information.
Windlass - The WINDLASS switch activates the
windlass. A circuit breaker is located on the battery
switch panel. Refer to the Section M-12 in this manual
and the manufacturer’s literature for additional
infor mation.
Engine Hatch - The ENGINE HATCH switch is used
to raise and lower the engine lid by activating a linear
screw jack. Pressing the upper portion of the switch
marked “UP” allows the engine lid to be raised.
Pressing the lower portion of switch marked “DOWN”
lowers the engine lid.
Wiper - The WIPER(S) switch activates the desired
wind shield wiper(s). The wiper(s) will self park.
B. Installation of Additional 12 Volt Equip ment
Accessories may be added to the boat by wiring
directly to the cabin panel. Non-factory in stalled
12 volt accessory equipment can be con nected to
the “ACC” switch on the dash.
Accessories - Additional 12 volt equipment may be
added to the boat by the using the accessory switch-
es. Depending on the model, certain accessories may
be wired directly to the fuse block below the dash or
may be wired to a circuit breaker in the AC/DC cabin
panel. For additional information on adding accesso-
ries, refer to Section H-5B.
12 Volt DC Receptacle - Permits the use of additional
12 volt equipment such as a cell phone. Using the
appropriate adaptor, the equipment draws power from
the boat’s batteries.
Aft Bilge Pump - The BILGE PUMP switch is used
to manually activate the bilge pump in the engine
compart ment. The bilge pump is used to remove
water from the bilge (bottom of the hull) area of the
boat by pumping that water over board. The aft bilge
pump is equipped with an automatic bilge switch and
will operate whenever bilge water rises to a level that
will cause the float to move upward.
This automatic bilge pump is active even if the battery
selector switch is in the “OFF” position or if no battery
selector switch is installed. The auto matic bilge pump
circuitry is connected direct ly to the batteries. When
leaving your boat unattended for an ex tend ed period,
check the charge on the battery(s) periodically. Also
check the water level in the bilge and make sure the
float switch is functional.
If the auto matic bilge pump must be dis abled, dis con-
nect the wiring plug near the bilge pump.
Blower - The BLOWER switch is used to activate the
bilge blower. Pressing the switch to the “ON” position,
activates the electric bilge blowers, changing the air in
the engine compartment that may contain gas vapors.
Gasoline vapors can explode resulting in injury
or death. Before starting the engine, check
engine compartment bilge for gasoline or
vapors. Operate blower for four minutes, and
verify blower operation. ALWAYS run the
blower when the vessel is operating below
cruising speed.
Cockpit Lights - The COCKPIT LTS switch is used to
activate the cockpit (courtesy) lights. An additional
cockpit light switch is typically located on the cabin
light switch panel.