Foss Infratec 1241, Service Manual

Page: 113 / 212

Infratec™ 1241 Grain Analyzer
Service Manual 1001 5015 / Rev. 4 4:45
4.12.7 Error Word 3
"Sub-error", presents a more detailed information about what went wrong when the
error occurred.
Position in instrument Hardware Error Code in bold:
E.g. "20 - 304/1ef3/201/20/0/ 0 /0/450".
4.12.8 Error Word 4 bit encoding (0x0108)
(Bit 0=LSB).
Position in instrument software error code: "8000-103/1ef3/0/1/0/1/ 1 "
4.12.9 DSP Version
The last figure shows the DSP version.
E.g. "20 - 304/1ef3/201/20/0/0/0/ 450 ", where 450 means DSP Version 4.50.
Id (hex) Specification Note Source
0001 MonochromatorFailed
Monochromator command
failed
Monoch.
0002 MonochromatorUnknown
Unknown monochromator
command
Monoch.
0004 MUIllegalCommand Illegal command sent to MU MU
0008 MUUnknownCommand Unknown command sent to MU MU
0010 TWMIllegalCommand Illegal command sent to TWM TWM
0020 TWMUnknownCommand
Unknown command sent to
TWM
TWM
0040 DetectorMaxGainSet
Maximum gain set when
scanning
DSP
0080 EIDFailed EID command failed EID
0100 EIDUnknown Unknown EID command EID
0200 EIDTimeOut EID communication timed out EID
0400 STMFailed STM command failed STM
0800 STMUnknown Unknown STM command STM
1000 STMTimeOut STM communication timed out STM
2000 SPORTFailure
Serial port communication
failure
DSP
C000 Not used - -
Id (hex) Specification Note Source
00FF
I
2
C ModuleErrorDebug HW I
2
C module debug data
I
2
C -
modules
FF00
I
2
C ModuleErrorByte HW I
2
C module error byte
I
2
C -
modules