5. Installation
5.4 Connecting the Power Supply
TIP
The measuring device has an integrated protection against
reverse polarity.
If the polarity of the power supply is incorrect, the measuring
device is protected against damage.
Figure 10: PWR
connector
Connecting the power supply:
1.
Switch off the power supply.
2.
Attach the cable of the power supply to the MC 1,5/ 2-
GF-3,81 connector.
Observe the pin assignments (+) and (-) on the PWR
connector.
3.
Connect the MC 1,5/ 2-GF-3,81 connector to the PWR
connector.
4.
Switch on the power supply.
5.5 Connecting a Sensor
NOTICE
Poor signal quality due to dust and dirt on the sockets and
connectors.
Optical connections are very sensitive to dust and dirt.
u
Ensure a clean working environment.
u
Seal sockets and connectors with dust caps when not in
use.
u
Clean sockets and plugs with a optical connector cleaner
before connecting.
TIP
The assignment of channels and sensors depends on the
application of the Blackbird OECD.
If available: Observe the color coding of the sensors and
channels.
© fos4X 2020
MDE1185_4-10_1.3.x_5.0_Blackbird
OECD_(6CH, ETH)-en-us
29 / 48
Summary of Contents for Blackbird OECD MDE1185
Page 48: ......
