Bridge GUI Guide: Network Configuration
55
If you want to subscribe to a new multicast group:
Click
NEW
MULTICAST
GROUP
.
In the
Add a Multicast Group
dialog, specify the
Access interface on which the current MP will
subscribe to the multicast group:
From the
Interface
dropdown, select a BSS
currently configured on (one of) the MP’s
radio(s) or one of the MP’s Ethernet ports.
or
Leave
Interface
at the default,
New BSS
, and
enter a valid
BSS Name
, as it will be (or is
currently) configured on (one of) the MP’s
radio(s).
Enter a MAC or IPv4 or IPv6
Address
for the
multicast group.
From the
Mode
dropdown, select whether the MP is
subscribing is as a multicast
Listener
,
Talker
or
Both
(refer to Section 3.2.1.7).
Click
APPLY
in the dialog (or
CANCEL
the action).
and/or
If you want to change the
Mode
of an existing
subscription:
Click the
EDIT
button for the subscription’s entry.
In the
Edit a Multicast Group
dialog, select a new
value for
Mode
(you cannot change the
Interface
or
Address
).
Click
APPLY
in the dialog (or
CANCEL
the action).
To delete Neighbor Costs or Multicast Groups:
You can delete a single entry or all entries in either list.
1
Log on to the Bridge GUI through an
Administrator
-level
account and select
ADVANCED
VIEW
in the upper right corner
of the page, then
Configure
->
FastPath Mesh
from the menu
on the left.
2
In the
FastPath Mesh
screen’s
Neighbor Costs
or
Multicast
Groups
frame:
If you want to delete a single entry, click to place a
check in the box beside it; then the
DELETE
button
above the list.
or
If you want to delete all entries, click
All
to place a
check in all entries’ boxes; then click the
DELETE
button
above the list.
The relevant list reflects the deletion(s).
