30
MANUAL TRANSMISSION MODE
MANUAL TRANSMISSION INSTALLATION: OPTION 15
TACH WIRE = White/Red must be connected and programmed. (Default = Tachless Mode)
HAND BRAKE = Green wire on 9 Pin Low Current Plug. (Default = Start Activation)
After programming Option #15-1, #15-3 or 15-4 for manual transmission mode, the Door Trigger and Hand Brake
wire must be connected for the manual transmission remote start procedure. The Green “Start Activation” wire
becomes a Hand Brake input that must be used for the manual transmission remote start procedure. A Databus
module can also supply the Door and Hand Brake status signal on most late model vehicles. Please check Databus
module features before connecting door and hand brake wires. A door opening will now cancel a remote start that
was previously “set-up” by the user. The Hand Brake and Door Trigger is a safety feature to cancel a remote start.
Note: You can’t use the interior lights as a door trigger if the interior lights turn on with ignition off.
OPTION 15 - TRANSMISSION TYPE: Manual Transmission Requires Tach Wire Connected and programmed.
This option selects automatic or manual transmission mode - 3 Choices of operation.
1.
Manual Shift Transmission - Requires Remote Start Button pressed with (-) Hand Brake set.
2. Automatic Transmission – Default.
3.
Manual Shift Transmission – Starts Exit procedure with (-) Hand Brake Set and engine running.
4.
Manual Shift Transmission – Starts Exit procedure with (-) Hand Brake Set, engine running and auto shut
down after last door closed.
MANUAL TRANSMISSION EXIT PROCEDURE:
1.
Option 15-1:
With engine running and vehicle in neutral, set parking brake, then press “Start” button on
transmitter. The remote starter will turn on and take over operation of the vehicle.
2.
Option 15-3:
With engine running and vehicle in neutral, set parking brake. The remote starter will turn on and
take over operation of the vehicle.
3.
Remove key, exit vehicle (remote starter unit must “SEE” door opened, then closed with engine running).
4.
Press Lock button within 10 seconds of closing door for “Idle Down” (engine stays running). Press Lock a 2
nd
time to cancel “Idle Down” (engine turns off) and set up Manual Transmission Mode.
5.
Press Lock button after 10 seconds to Lock the doors and shut down the engine. The system will remote start
the engine unless a door is opened.
