Wireless settings
System Wireless
FortiGate Version 4.0 Administration Guide
164
01-400-89802-20090424
To add a wireless interface
1
Go to
System > Network > Interface
.
2
Select
Create New
.
3
Complete the following:
4
In the Wireless Settings section, complete the following and select OK:
Figure 82: Wireless interface settings (WEP)
Figure 83: Wireless interface settings (WAP)
Note:
You cannot add additional wireless interfaces when the FortiWiFi unit is in Client
mode or Monitoring mode.
Name
Enter a name for the wireless interface. The name cannot be the same
as an existing interface, zone or VDOM.
Type
Select
Wireless
.
Address Mode
The wireless interface can only be set as a manual address. Enter a
valid IP address and netmask.
If the FortiWiFi is running in Transparent mode, this field does not
appear. The interface will be on the same subnet as the other interfaces.
Administrative
Access
Set the administrative access for the interface.
SSID
Enter the wireless service set identifier (SSID) or network name for this
wireless interface. Users who want to use the wireless network must configure
their computers with this network name.
SSID Broadcast
Select to broadcast the SSID. Broadcasting the SSID enables clients to
connect to your wireless network without first knowing the SSID. For better
security, do not broadcast the SSID. If the interface is not broadcast, there is
less chance of an unwanted user connecting to your wireless network. If you
choose not to broadcast the SSID, you need to inform users of the SSID so
they can configure their wireless devices.
Summary of Contents for Gate 60D
Page 705: ...www fortinet com...
Page 706: ...www fortinet com...