Configuring the modem interface
System Network
FortiGate Version 4.0 Administration Guide
140
01-400-89802-20090424
Configuring modem settings
Configure modem settings so that the FortiGate unit uses the modem to connect to your
ISP dialup accounts. You can configure up to three dialup accounts, select standalone or
redundant operation, and configure how the modem dials and disconnects.
For FortiGate-60B and FortiWifi-60B models with modems, the modem can be a
management interface. When enabled, a user can dial into the unit’s modem and perform
administration actions as if logged in over one of the standard interfaces. This feature is
enabled in the CLI using
config system dialinsvr.
If VDOMs are enabled, the modem can be assigned to one of the VDOMs just like the
other interfaces.
If the modem is disabled it will not appear in the interface list, and must be enabled from
the CLI using:
config system modem
set status enable
end
Figure 68
shows the only the settings specific to standalone mode. The remaining settings
are common to both standalone and redundant modes and are shown in
Figure 69
.
Figure 68: Modem settings (Standalone)
Note:
You cannot configure and use the modem in Transparent mode.
Summary of Contents for Gate 60D
Page 705: ...www fortinet com...
Page 706: ...www fortinet com...