DSE
Canada Inc
INSTALLATION GUIDE
FS 105
with ALARM
TECHNICAL SUPPORT 514-255-0446 & 1-800-667-6820
5540 Boul. Metropolitain Est, St-Leonard, Qc., H1S 1A6 Tel. : 514-255-2720 Fax : 514-255-1367
FAR 040526
11/08/04
1
CERTIFIED ISO 9001 PRODUCT
Manual or Automatic transmission
The command module is set by default to operate in
a vehicle equipped with a Manual transmission.
For an Automatic transmission refer to
Fig 1
and cut
the loop.
Note
:
Remember to always
reset
the unit ( power off/on) after cutting the loop
A -
To code the transmitter
(Hand brake must be
On
or
White/Blue
Grounded
)
1
-
It is mandatory to
override
the starter kill and to
reactivate
it before proceeding to the
following steps :
a
-Turn the key to
Ign On
and
within 6 sec,
press and
hold
the programming button ,
system will
chirp once
with
1 parking light flash
and LED will stay On for 5 sec then Off
for 5 sec continuously
(system is NOW in Valet/Override).
Turn Off Ignition.
b
-Repeat the same procedure as in above
step a
, system will
chirp twice
with 2
parking
light flashes
and LED will turn Off . Turn Off Ignition.
2
- Immediately after the system chirps twice,
turn the key to
Ign On
, within 6 sec , push
and release
Slowly
foot brake pedal 3 times = LED will flash rapidly, press LOCK
button of the transmitter immediately (within 5 sec).
One long chirp
will sound to
confirm with parking lights flashing.
To code a second and third transmitter, press same LOCK button of the respective
transmitter one after the other.
B - O
VERRIDE
V
ALET
(Sleep Mode)
To Override the alarm and starter kill
1
-Turn the key to Ign On and
within 6 sec.
2
-Press and
hold
the programming button .
3
-Siren or horn will stop sounding, alarm and
starter kill will be cancelled instanly in
case of lost or malfunction of the
transmitter.
To
reactivate
the alarm function, repeat step
1 and 2 . System will chirp Twice (2) with 2
parking light flashes
to confirm.
To put the system in “Sleep Mode” for car
servicing or in “Valet Parking”
1
-Turn the key to Ign On and
within 6 sec.
2
-Press and
hold
the programming button
3
-System will chirp Once (1) with 1
parking
light flash
for Valet mode activated (On).
LED will stay ON for 5 sec then Off for
5sec continuously.
4
-To turn Off the “SleepMode” or the “Valet
Parking”, repeat steps 1 and 2. System will
chirp Twice (2) with 2 flashes to confirm.