POS-Line High Bright IoT
30
10. POS-Line High Bright IoT
The POS-Line IoT monitor is equipped with the Raspberry
®
Pi compute module 3+ (CM3+). The specification can be found under the
following link:
https://www.raspberrypi.org/products/compute-module-3-plus/
Note:
The full driver package for the IoT monitor can be found on our website:
https://www.distec.de/en/service/downloads/
The device is equipped with a battery. Please note the following:
•
Disconnect the devise from the power supply before replacing the battery.
•
If the battery is not replaced properly there is a risk of explosion.
•
Always replace the battery with another one of the same type.
•
Supply empty batteries to the local waste battery return system. Please also observe the notes in chapter „Disposal“.
Passive cooling
Monitors of the POS-Line High Bright IoT series are equipped with a passive cooling system. Passively cooled monitors divert the
heat of the processor to the monitor‘s housing. Passively cooled devices have no moving parts.
Spezification
Please refer to the current data sheet for the details of the IoT monitor specification.
Connectors of POS-Line High Bright VideoPoster series
Connecting to a network using a patch cable
LAN
LAN
HDMI IN
LAN
Line-out
USB
USB
Micro-SD-Karte
Reset Button
LED
OSD Tastatur
Stromversorgung
Ein/Aus Schalter
USB (IoT)
