Setup
69
3. Confirm your entry with
.
5.11
Communication
5.11.1
Printer
Current animal lists can be generated via the automatic feeder’s printer function.
•
Serial:
Select this option if you have connected a printer to the automatic feeder via the se-
rial interface.
•
CAN:
Select this option if the printing data is to be sent via the CAN bus. In this case, a PC
program will play the counterpart.
5.11.2
Network configuration
Here you can configure all parameters of the network.
•
(M) MAC address:
Here you can see the MAC address of your network. Your processor
card is uniquely identified via its MAC address. This address cannot be changed.
•
M-ECN:
Here the check sum of the MAC address is displayed.
•
(IP) IP address:
Here you can see the IP address of your processor card and if necessary
change it.
•
(SN) Subnet mask:
Here you can see the subnet mask of your network and if necessary
change it.
•
(GW) Gateway:
Here you can see the IP address of your gateway and if necessary change
it.
•
IP assignment:
If you set the value here to
DHCP
, your processor card will try to get its IP
address from a DHCP server in your network. If you select
static
here, you will have to set
the IP address of your processor card yourself, in consultation with your IT specialist.
Note:
If after 10 seconds no IP address has been set by the DHCP server, the IP address
169.254.2.1 will be used automatically.
•
Accept?:
Press here
. The data will be saved.
5.11.3
Cloud
Here you can change the values for the CalfCloud and the automatic feeder's Internet connec-
tion to the cloud.
1. In
start?
, press
. You then create the connection between the cloud and the automatic
feeder.
2. You will see the message
You hereby accept the data protection provisions listed on
www.calf-cloud.com!
.
3. Press
. The error menu
last error
will appear.
•
none
. There are no errors present.
•
no eth. cable
. No Ethernet cable is plugged in.
•
no Internet
. There is no Internet connection available.
•
connect.error
. There is a connection error to the server.
