Installation and
Operating Manual
Forno Bravo
Casa2G and Premio2G
Residential Modular Refractory Ovens
24
©Forno Bravo, LLC 2019. All Rights Reserved.
Ver. 2.0
5.2. Seal the outside of the oven dome joints.
Seal the outside of the oven dome joints with a
2" w x 3/4" h (50 mm x 19 mm) band of high temp
mortar.
5.3. Dome assembly.
Seal the intersection between the oven dome and
vent and the insulating board with a 2"w x 3/4"h
(50 mm x 19 mm) band of high heat mortar.
The oven has the option of a decorative brick vent
arch. The arch attaches to the front of the oven dome
body and vent assembly. A custom, site-built arch can
also be used, and can be constructed from virtually
any non-combustible material.
You do not need to coat the outside of the oven
dome with additional mortar. The oven dome is
made using a high density castable refractory
material that provides excellent heat hold
capacity.
6. Chimney Installation
Overview
Your oven can be attached to one of three types
of chimney system: the single wall stainless steel
chimney supplied with the oven, a UL103HT Listed
chimney system, or a refractory chimney flue liner.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE
SERVING ANOTHER APPLIANCE. DOING SO MAY
RESULT IN FIRE.
The table below outlines the internal dimension of
the chimney system recommended for each oven
size.
Oven Size
Chimney Internal
Diameter
Casa2G80/90
6" (15 cm)
Casa2G/
Premio2G 100/110
8" (20 cm)
Premio2G120
8" (20 cm)
Single Wall Chimney for
Outdoor Installation
Each oven contains a 24" (60 cm)section of single wall
stainless steel pipe with an anchor plate and rain cap,
intended for outdoor installations. Additional 24" (60
cm)sections of pipe can be added to meet specific
installation requirements.
Do not use single wall chimney pipe on indoor
installation.
