Preparation and Setup |
17
The Form Cure is ready to use once the turntable is installed and the power is connected. Each
cycle requires time to preheat before the 405 nm lights begin post-curing. The preheating time
depends on the current temperature and the target post-cure temperature.
4.4
Transporting Form Cure
Refer to
2.2 Technical Specifications
for product weight and dimensions. Keep the packaging
for transportation or shipping.
The Form Cure complete packaging kit consists of:
• 1 outer cardboard carton
• 1 foam bottom insert
• 1 foam upper insert, which holds the small accessory boxes
• Plastic wrap
Original packaging is required for warranty service. Do not ship with uncured resin
inside the device. Resin left inside can damage the product in transit, which may lead
to additional fees or void the warranty.
To prepare to transport the Form Cure:
1. Remove the turntable.
2. Wipe residual resin from all surfaces.
3. Close the cover.
4. Wrap the Form Cure with plastic wrap to secure the cover.
5. Reassemble the box.
6. Place the bottom foam insert in the box.
7. Place the Form Cure on top of the bottom foam insert.
8. Place the upper foam insert on top of the Form Cure.
9. Seal the box with tape.
When shipping a machine to Formlabs for service, do not ship the accessory tools
or the power supply. Accessories will not be returned after service. The product’s
original packaging is required for warranty service. Contact other authorized resellers
for unique guidance on shipping requirements.
NOTICE
NOTICE
4
5
