background image

FD 8650CC AutoOiler

Cross Cut Paper Shredder

OPERATOR MANUAL    

FIRST EDITION

8/2010

Safety Devices and Other Features

Formax 8000 Series Shredders are equipped with various safety features:

Automatic Reverse Rotation

When too much paper is inserted, the cutter stops operating and 

automatically rotates in reverse to discharge the jammed paper. An alarm 

sounds. Reduce the amount of paper and restart the operation.

Door Switch

If the door is open, the shredder will not operate.

Automatic Stop

When the shredded paper fills the wastebasket, the “FULL” light comes on 

and the cutter stops operation. Open the door, remove the wastebasket and 

empty paper scraps. Replace the wastebasket, close the door and continue 

operation.

Automatic Power Shut-Off

• If the shredder operates continuously for more than 30 minutes, the power 

is automatically shut off.
• If the motor is overloaded, the “STOP” LED will flash until it cools down.  

When the flashing stops the shredder is ready to be used again.

Maintenance

• Disconnect power by pulling power cord plug from wall outlet.
• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use a 

   neutral detergent, then wipe again with a soft cloth.

CAUTION:

• Never put water directly on the surface of the shredder.

• Never clean the case with benzene or thinner, since it will cause discoloration. 

• Do not dismantle the shredder. Contact your Formax Dealer for service.

Reviews: