31
Chapter 2 Basic Operation
[a]
[b]
Stack paper striking the leading edge of paper
lightly at the shutter. [a]
If there is some clearance between the
leading edge of paper and shutter, the
paper detecting sensor [b] does not
function properly.
3
Adjust the paper feed guide to match
the paper size.
Set the paper feed guide in such a way that it
touches the paper lightly.
• Do not press the paper with the paper
feed guides too strongly. Otherwise,
paper feed errors such as mis-feed will
occur.
• If the guides are positioned incorrectly,
the automatic paper size detection
function will not work, and the
key or
key,etc. will not operate.
4
Tighten the guide fixing screws.
Make sure to tighten the guide fixing screws on both right and left sides. If the screws are not
fixed, the paper feed guide moves during operation, and folding misalignment may occur in the
right and left direction.
5
Set the trail edge guide unit to the rear
end of paper.
Set the trail edge guide unit so that it will be in
contact with the paper lightly.
Make sure to place the trail edge guide
unit. When starting the machine without it,
the paper will be blown by separating air.
When processing long paper, use the plate unit and
side guide unit.
Range of paper length: A3 (LGR) or more, ortrail
edge of paper is positioned at more than two-third
of auxiliary paper feed tray.
