Rev0.Jan 5, 2018 SD 13Q17 Page
1
of
4
3M Double-sided Body Moulding Tape
Phillips Screwdriver # 2 Long Shaft
- Already applied to the visor
Tape Measure
2
– Surface Cleaner
Masking Tape
4
– Adhesive Pedestals
4
– # 6 x 5/8” Flat Head Screws
4
– Pins
1
– Wooden “Wet-out” stick
Attention
: This product uses a 3M adhesive that requires installation and curing temperatures of 15° to 43°C (60° to 110°F) for 1 hr to
develop maximum adhesion to the vehicle surface.
Failure to install this product at the proper temperature or allow adequate
curing time before use is not covered under warranty.
1. Insert a pin through the hole in the side visor and into the adhesive backed pedestal.
Note:
See illustration below for pedestal
orientation.
Maintain slight pressure on the pin, to ensure proper seating of the components, while simultaneously tightening the
screw. Repeat for other three pieces.
2. The visors mount to the window frames of the doors. Make sure that those areas are clean and dry.
3.
Start
with the Passenger’s side front door of the car.
4. To understand how the visor
will fit, place the front Passenger’s door visor up to the car. Align the end of the visor with the edge of
the door as shown on next page. The pedestal attached to the visor rests on the door frame. The top edge of the visor runs flush
along the top edge of the window frame.
5. Clean all the mounting areas aggressively with the surface cleaner to remove any finger prints, oils or waxes that may be on the
surface.
6. Starting at the pedestal end peel the first 30-40 cm (12-15 inches) of the protective backing from the adhesive tape on the flange
of the visor. Press the visor into place as determined above. Work forward, removing the protective backing from the tape and
pressing the part into place.
Pedestal Orientation
Adhesive
Pedestal
Orientation
Protective Backing Pull Tabs
Side Window Visors
Installation Instructions
SD 13Q17
Nissan Qashqai /
Rogue Sport (2017-up)
