HARDWARE KIT
TOOLS REQUIRED
2
– 3M Adhesive Promoters
None
1
– Alcohol Wiping Pads
Attention
:
This product uses a 3M adhesive product that requires installation and curing temperatures of at least 20°C/ 70°F for 24 hours to develop
maximum adhesion to the surface.
Failure to install this product at the proper temperature or allow adequate curing time before use is not covered
under warranty.
1.
Attach the “E” clips to all 4 visor pieces. Note the orientation of the clip. See illustration.
2.
Test fit the visor to the door frame before attempting final installation. Open the front door and place a front visor into position by hooking the mounting clips
(already attached to the visor) over the top edge of the door frame. See illustration.
3.
Adjust the visor so that the end of the visor is flush with the back edge of the door. Test fit the rear visor in the same manner, making sure the front edge of
the visor is flush with the front edge of the door. Open and close the doors to ensure there is no interference with the visors. Remove the visors.
4.
Clean the mounting area aggressively with alcohol wiping pad to remove any finger prints, oils or waxes that may be on the surface. Prime the contact area
on the window frame with the adhesion promoter provided.
5.
Starting at the back edge of the visor, peel the first 50mm (2 inches) of the protective backing from the tape on the horizontal flange of the visor. Peel the first
50mm (2 inches) of the protective backing from the vertical flange as well. Fold back the protective backing from the tape as shown in the illustration.
6.
Reposition the visor on the window frame as described in steps #2 and #3. Adjust the visor for best fit. While pressing the visor into place, pull the protective
backing out from between the visor and door frame without disturbing the fit of the visor.
7.
Once the visor is in place, press down hard along the entire mounting flange to ensure that the tape is fully adhered to the vehicle.
8.
Remove any residue of adhesion promoter with the alcohol wiping pad.
Thank you for purchasing
side window visors.
Retain sheet for Care Instructions and Kit Information.
SD 13B13 Rev0.Jan 5, 2018
Protective Backing
Exposed Adhesive Tape
3M Primer 94 Instructions
-Squeeze tube in middle to break inner ampule
-Apply to clean, dry surface
-Allow at least 5 minutes to dry before taping
Visor Mounting Clip
Visor
Door Frame
Side Window Visors
SD 13B13
Installation Instructions
Nissan Sentra 2013 - up
