FORM FIT HDW 9K 05 Manual Download Page 1

 

FORM FIT 

HOOD PROTECTOR 

 

   

Honda Odyssey 2005 -   

 

 

 

 

 

 

 

                 

HDW 9K 05

 

Hardware

 Kit 

Tools Required

 

6 – Large Bumpons 

1 – Phillips Screwdriver #1 

6 – 3M Anti-abrasion Film Pads 

1 – Phillips Screwdriver #2 

6 – Black ‘C’ Clips 

 

 

 

 

 

 

1 – Tape Measure 

6 – #6 x 3/8” Screws 
6 – #4 x 3/16” Screws

 

Installation

     

 

1. 

Be sure that the hood is clean and dry inside and out. Open the hood of the vehicle. 

2. 

Install the bumpons as shown in 

Illustration #1.  

Attention: The bumpons must be installed on the hood, not on the protector!!!. 

If the bumpons are 

installed on the protector, they will wear through the paint. 

3. 

Center the protector on the hood, resting on the bumpons.  

4. 

Peel and fold an anti-abrasion film pad in half over the edge of the hood, underneath each of the  two (2) inner holes in the protector. 

See Illustrations #2. 

 

5. 

Slide the “C” clips on the hood in line with the holes in the protector. Be sure that the “C” clips are well seated against the hood; it may be necessary to tap 
on the clips. 

See Illustration #2.

 

6. 

Be sure that the hole in the top of the clips lines up with the hole in the protector, then tighten the #6 x 3/8” screws, through the protector and into the top of 
the “C” clips. 

Do not over tighten

See Illustration #2.

 

7. 

Make sure all the clips are well seated against the hood. Tighten the #4 x 3/16’’ screws in the back of the “C” clips. 

See Illustration #2.

 

8. 

Repeat steps #4, 5, 6 and #7 for the other four (4) holes. 

9. 

On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance. 

Note: Do not pull on the protector when opening or closing the hood.

 

Care Instruction                         

Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents.

  Periodically check to make 

sure that the bumpons are in place and that the protector is secure. 

Avoid using automatic car washes.

 Do not pull on the protector when opening or 

closing the hood. 

Illustration #1: Bumpon Location                       

 

 

 

 

 

 

 

 

 
 

8 ½”

5” 

1 ½”

9” 

21”

 
 
 
 
 
 
 
 
 

 

 

Illustration 

#2: 

Clip 

Location 

and 

Configuration 

        

 

 

Clips (Step #7)

 

 
 
 
 
 
 
 
 
 
 

Clips (Step #4 & #5) 

 

Thank you for purchasing a 

form fit

 hood protector.

 

Retain this sheet for care instructions and kit information

 

 

Made 

in 

Canada 

     

      Rev0.050121 

 

 

Reviews: