Illustration
#2
–
Pedestal
Location
and
Alignment
Hood
Pedestal
Fingers
(Sit against the trailing
edge of the molding)
Molding
Illustration
#3
–
Protector
Install
Illustration #4 – Clip Configuration – Patent No. 6,892,427
Step #10
Step #11a
Step #11b
Step #11c & 11d
10. Peel and fold an anti-abrasion film pad in half over the edge of the hood underneath each of the two (2) inner holes in the protector. See
Illustrations #1 & #4
– Step #10
11. a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in
Illustration #4 – Step #11a
.
b) Insert a pin through the protector into each of the clips,
See Illustration #4 – Step #11b.
c) Insert a #6 x 5/8’’ screw through an ‘L’- bracket and into the clip.
See Illustration #4 – Step #11c & 11d.
d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.
12.
Repeat steps #10 and #11 for the other two (2) holes.
13. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
CARE INSTRUCTIONS
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or
solvents
. Periodically check to make sure the bumpons are in place and the protector is secure.
Avoid using
automatic car washes
. Do not pull on protector when opening or closing the hood.
Thank you for purchasing a
form fit
hood protector. Retain this sheet for care instructions and kit information.
Made in Canada
Rev0.110628
