Section 7
CARE AND MAINTENANCE
WaterPur
TM
Operating Instructions (Cont’d)
WaterPur
TM
The
WaterPur
TM
cartridge is not to be autoclaved or steam sterilized. Use the
WaterPur
TM
cartridge with
microbiologically safe water. Activated carbon filters are not designed to kill or remove bacterial or
viruses. Actual results obtained will vary with various combinations of organic contaminants, changes in
pH or other conditions encountered in actual use. All information presented is based on data believed to
be reliable. It is offered for evaluation and verification, but is not to be considered a warranty of any kind.
The contaminants removed by the
WaterPur
TM
cartridge are not necessarily in your water. Some
jurisdictions tax, regulate, or restrict devices making health related or aesthetic claims.
WaterPur
TM
makes no claims in those jurisdictions.
WaterPur
TM
The
WaterPur
TM
system is warranted against defects in material and workmanship for a period of one
year from date of purchase. Warranty does not cover damage due to abuse, neglect, improper
installation, exposure to pressure or temperature above or below stated operating parameters, or
improper winterizing.
The Seller makes no other warranties of any kind, expressed or implied, concerning this product,
including warranties of merchantability or fitness for a particular purpose, except that this product
should be capable of performing as described in this manual.
Seller’s obligation for this product’s performance below specifications shall be limited solely to the
replacement of product proven defective, at the Seller’s sole discretion. Determination of suitability of
product for uses contemplated by Buyer, shall be the sole responsibility of Buyer. Use of this product
constitutes Buyer’s acceptance of this limited liability.
WaterPur
TM
The
WaterPur
TM
Model CCI-10CLW12 is a Household Class, Group 2, water filtration device designed
for installation in recreational vehicles. It has a micron rating of 1 micron, a capacity of 10,000 gallons
of chlorine removal at 2.5 gallons per minute. This capacity was determined under WQA Standard
S-200 Test Conditions, and may vary with local water characteristics.
The cartridge consists of activated carbon particles fused into a uniform block with enhanced absorptive
capacity and efficiency. The cartridge flows in a radial outside-to-inside direction providing increased dirt
capacity and low pressure drop (8 psid @ 1 gpm service flow, maximum differential pressure of 100 psid
and a collapse pressure of 200 psid).
Unlike granular activated carbon (GAC) filters, the extruded carbon will not channel or bypass, due to the
extreme uniformity of its extruded activated carbon core. Service life is greatly extended by a layer of 15
micron polypropylene spun-bonded prefiltration medium and a second layer of 5 micron polypropylene
melt blown filter medium.
Maximum cartridge operating pressure is 125 psid and maximum operating temperature is 125O F.
Minimum operating temperature is 400 F. The housing and cartridge are constructed of 100% NSF
listed materials.
Page 97
Revised September 2012
