Section 5
PLUMBING
To Disconnect from an Outside Source of Water
1. Turn off the outside source of water at the source.
2. Carefully disconnect the hose from the city water inlet connection. (Spraying may occur)
3. Remove the hose and store.
4. Reinstall the cap on your Aviator city water inlet connection.
When an outside source of water is unavailable, water can be drawn from the fresh water storage tank in
your Aviator. The Fresh Water Tank is filled through a gravity controlled water spout located on the off
door side under the front compartment door. See picture below.
1. Remove the water fill cap.
2. Water can now be added directly to the tank through the fill spout by use of a known clean hose or
other known clean water filling container, used only for this purpose.
3. When the Fresh Water Tank is full, replace the water fill cap.
• FILL CAP FOR FILLING TANK
• ONE END OF THE FRESH WATER SUPPLY HOSE GOES INTO THE FILL
SPOUTAND THE OTHER END GETS CONNECTED TO A KNOWN CLEAN
OUTSIDE SOURCE OF WATER APPROVED FOR HUMAN CONSUMPTION.
NOTE: WHEN FILLING THE SYSTEM, YOU MAY WANT TO ADD MORE WATER TO THE
TANK TO REPLACE THE WATER USED WHEN FILLING THE HOT WATER TANK
AND WATER LINES.
Page 55
Revised September 2012
