Tongue and Groove
4' x 3' Shed
Issue 0215
B
MSLSH43DE
DOOR END
D
E
F
MSLSH43 PARTS LIST
MTSLSH43DR
DOOR
9107008
ROOF SHEET
QTY 2
G
Place the panels on top of the floor. Make sure that all the panels are tight and flush
before fixing them to each other using 3x50mm screws.
When the panels are secured to each other, make sure they are square and fix to the
floor using 3x50mm screws for each side panel. Use 2x50mm screws for the plain and
door end panels, ensuring that the screws are located into the bearers underneath.
Top View
B
C
2
1
1
C
Place and secure two hinges to the door so that they line up with
the battens on the reverse, using 25mm
Security Screws
for each.
Place the door into the door end ensuring that the door is square.
Fix the doors in place using 3x25mm
Security
Screws
for the other
section of each hinge.
3
B
Fixing Pack (MSLSH43FP)
Not to Scale
REQUIRED TOOLS :
(NOT SUPPLIED)
POZI DRIVE SCREWDRIVER
SPIRIT LEVEL
TAPE MEASURE
HAMMER
Tee Hinge Qty 2
30mm Screw Qty 12
IMPORTANT, RETAIN FOR FUTURE REFERENCE; READ
CAREFULLY
Check all parts prior to assembly
This buildings is presure treated to ensure longevity of all
timber components and to protect against rot. This may leave
a colour difference on some parts that will even out as the
moisture content stabilises. This will not require additional
treatment.
- Timber is a natural material. It will shrink and swell as a
result of varying moisture content.
- Please keep all plastic bags and small parts away from
children
- The roof of this building is not a load bearing structure.
- This product must be built on a solid level base.
Technical Help line:
0333 7777 089
8.30 am and 5.00
pm Monday to Friday.
In line with your statutory rights, please check all parts prior
to assembly, as assembly of damaged parts may be deemed
to be acceptance and this may affect the remedies you are
entitled to. If the product is not constructed in accordance
with the instructions, or is altered in anyway (e.g. painted),
the manufacturer cannot be held liable for any resulting
damage.
H
Important : Assembly of
this shed requires a
minimum of two adults.
HAMMER
Must Pre drill for
each screw used.
ROOF FELT
MSLSH43PS
PLAIN SIDE QTY 2
MSLH43PE
PLAIN END
FELT21BL
FELT QTY 1 ROLL
28280910PT
910mm BATTEN
QTY 2
A
Attention:
Take care
when placing
the screws.
These can
not be
backed out.
Fix the pad bolt to the doors so that it is in line with the batten on the back. Make
sure that both parts are positioned so that the bolt will locate correctly and keep
the doors locked. Fix the pad bolt in place using 8x25mm
Security Screws
.
10mm Felt
T
acks
Qty 100
25mm Countersunk
Security Screws Qty 24
Pad bolt
SHARP KNIFE
FOR ROOFING FELT
50mm Screw Qty 22
30mm Nail Qty 32
MSLSH43FL
FLOOR
40120720PAII70PT
BARGE BOARD
QTY 4
A
D
Attention:
Take care
when placing
the screws.
These can
not be
backed out.
