8
9
11
7
Forest Garden Ltd, Unit 288 Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB
Fix the ridge plate from inside the shed so that it bridges the two battens at the
apex together. Fix using 2 x 25mm screws
10
Biocidal Product Regulation (EU 528/2012) Article 58 Information
This article contains timber treated with Celcure AC-500, incorporating biocidal products to give protection against wood destroying insects & wood rotting fungi
.
Contains:
Basic copper carbonate (Copper (II) carbonate – Copper (II) hydroxide (1:1)), Boric acid, Benzalkonium chloride.
Wear gloves when handling freshly treated wood. Avoid breathing dust when cutting treated or untreated wood. Dispose of off-cuts responsibly – do not burn.
Before fixing the Hasp to the door make sure that it is in line with the framing on the
reverse of the door and closes over the Staple. Fix this in place using 2 x 25mm screws.
Position the Staple opposite, again making sure that it is in line with the framing behind
and fix it in place using 3 x 25mm screws.
Nailing through the roof sheet (G) in to the battens. Position the battens as shown.
1.The 2365mm batten (I) should be flush on all sides.
2.Place a 2275mm batten (J) so that it is offset 45mm on either side and has a 15mm offset on
the long side.
3.Place another 2275mm batten (J) in between, again with a 45mm offset on both sides.
Fix each batten in place using 30mm nails spaced in 300mm intervals.
Lift the roof sections into place, making sure that they are in line with the apex and
the front and back panels of the shed.
Fix the roof in place using 30mm nails spaced in approximately 300mm intervals
(Make sure the nails locate into the framework of the side and end panels)
Unroll the felt and cut it into three equal lengths. Place a section on each eaves so that
there is a 50mm overhang on each edge as shown. Fix this to the roof using felt nails
spaced in 150mm intervals. Cut and fold the corners securing with a single felt nail for
each.
Place the remaining section as shown making sure that the it overlaps the others. Again
secure each sheet in place using felt nails spaced in 150mm intervals.
Place the barge boards against the ends of the building so that they are flush with
the overhang of the roof and in line with the top. Fix each in place using 3x40mm
screws.
Position the finial against each end of the shed so that they cover up the joins
where the barge boards meet. Secure each in place using 2 x 30mm screws.
Staple
Staple
Fix a Z’ bracket to
each end of the
2275mm battens
using a 25mm
screw for each.
B
J
15mm Offset
I
G
J
45mm Offset
Maintenance.
Regularly check all fixings are secure and the roofing felt has no holes or tears.
Sand off any rough/sharp edges.
F
pencil line
Attention
Take care when
cutting and
trimming the roof
felt.
Attention
Take care when
cutting and
trimming the roof
felt.
K
H
Place the window from the outside so that the lip sits on the bottom board as shown.
Place the plastic strips around the window so that one side butts up against the cladding.
Fix the strips and the window in place using 2 x security screws for each strip and one for the
top of the window.
6
N
Lip
Board
Attention:
Take care when placing
the screws. These can
not be backed out.
Using scissors
(carefully) cut the
plastic strips to
size.
G
