Get Connected
TIMS MVP
™
Setup and Configuration Guide
1
Get Connected
Connecting your TIMS Medical Video Platform (MVP) System comprises the following steps,
reviewed in this chapter:
▪
Conduct a Site Survey
▪
Set Region AC Voltage Setting
▪
Make Standard PC Connections
▪
Make Modality Connections
▪
Connect Trigger (optional)
▪
Configure Network
After you connect your system, additional software configuration steps are required before the
system is ready to use:
▪
Configure Security (optional)
Go to Page 74
▪
Configure Channels and DICOM Class Lists
Go to Page 27
▪
Configure Modality Worklist
See
Operator’
s Guide
▪
Configure DICOM Send
See
Operator’s Guide
Site Survey
Before you set up the hardware connections or software configuration for your TIMS MVP
™
system, you should perform a site survey to establish general requirements.
•
Determine requirements and location of TIMS units, including proximity to power and
network adapters.
•
Determine the type, number, and location of video imaging devices you will connect to
the TIMS MVP
™
system.
•
Determine if distances to video sources will exceed 6 meters, in which case a video
amplifier may be required.
•
Determine network settings (domain or workgroup, dynamic or static IP address, and so
on).
Summary of Contents for TIMS 2000 EN
Page 1: ...060000 91 Rev 1...
