Fore Systems forerunner series, Configuration Manual

Page: 298 / 352

D - 22
ForeRunner ATM Switch Network Configuration Manual
Configuring FramePlus Modules
D.6.5.2 Creating a FUNI PNNI SPVC
To create a FUNI PNNI SPVC, perform the following steps:
1. Configure the ingress FUNI PVC without specifying the
-oport
,
-ovpi
, and
-ovci
parameters. For example:
myswitch::configuration funi pvc> new 4A1:00 0 40 -epdppd 1 -name spvc_a
2. Display the FUNI PVC so you can see what
iport
,
ivpi
, and
ivci
values were
assigned to the PVC. For example:
myswitch::configuration funi pvc> show
FUNI FUNI Input Output
SvcId VPI VCI Port VPI VCI Port VPI VCI Status Eppd Name
4A1:00 0 40 4A1 0 40 up 0 pvc_a
3. Configure a new PNNI SPVC where the
<port>
,
<vpi>
, and
<vci>
values are the
iport
,
ivpi
, and
ivci
values that are displayed in step 2. The
dest
parameters
identify the endpoint of the connection. For example:
myswitch::configuration spvc pnni> new 4c1 0 100
47.0005.80.ffe100.0000.f21b.19cd:4a1 -destvpi 0 -destvci 40 -name spvc_a
NOTE
Usually, when creating a PNNI SPVC, the
-destvpi
and
-destvci
parameters are
optional (i.e., if these values are not supplied the
terminating switch uses the same VPI and VCI
values as the originating switch). However,
when at least one endpoint of the PNNI SPVC is
a port on a FramePlus network module, you must
specify these parameters.
This creates a bi-directional PNNI SPVC from the source to the destination where the ATM
portion of the interworking connection is supported via the SPVC logic.