Drilling and welding of frames and body structure
have to be conducted following the guidelines.
Please consult the Vehicle Converter Advisory
Service [email protected] for details.
Refer to: 5.1 Body (page 147).
Welding.
5.13.3 Area for Fitting Additional Body
Attachments to the Rear of the
Bumper
NOTE:
With the vehicle on level ground and with
all measurements taken rear ward of the bumper
bar edge. The area designated for the fitting of
attachment is defined as 220mm horizontally by
95mm vertical downward to the road surface,
with a max width of 1390mm about vehicle center
line.
It is not the manufactures recommendation to fit
additional body attachments (tow bars, steps,
bicycle racks and carriers) outside of the
designated area.
5.13.4 Water Tank on Camper Vehicles
NOTE:
It is recommended that a decal or label is
fitted adjacent to the filler aperture identifying the
correct fluid to be used, for example: 'Water only'
for water tanks.
Date of Publication: 04/2012
FORD
TRANSIT CUSTOM
2012.75
5 Body and P
aint
179
