PRINCIPLE OF OPERATION
WARNING
The system does not relieve you of
your responsibility to drive with due
care and attention.
Cruise control allows you to control your
speed using the switches on the steering
wheel. You can use cruise control when
you exceed approximately 30 km/h.
USING CRUISE CONTROL
WARNINGS
Do not use cruise control in heavy
traffic, on winding roads or when the
road surface is slippery. This could
result in loss of vehicle control, serious
injury or death.
When you are going downhill, your
vehicle speed may increase above
the set speed. The system will not
apply the brakes. Change down a gear to
assist the system in maintaining the set
speed. Failure to do so could result in loss
of vehicle control, serious injury or death.
Note:
Cruise control will disengage if your
vehicle speed decreases more than 16 km/h
below your set speed while driving uphill.
The cruise control switches are located on
the steering wheel.
Switching Cruise Control On
E201284
Press the button.
Setting a Speed
•
Accelerate to the desired speed.
•
Press and release
SET+
.
E71340
The warning indicator will
display in the instrument cluster.
•
Take your foot off the accelerator
pedal.
Changing the Set Speed
•
Press and hold
SET+
or
SET-
. Release
the control when you reach the desired
speed.
•
Press and release
SET+
or
SET-
. The
set speed will change in approximately
1 km/h (1 mph) increments.
•
Press the accelerator or brake pedal
until you reach the desired speed. Press
and release
SET+
.
Canceling the Set Speed
Press and release
CAN
or tap the brake
pedal. The system will not erase the set
speed.
Resuming the Set Speed
Press and release
RES
.
146
Ranger (), EB3B-19G219-ZAB enAUS
Cruise Control