1.
Pull the wiper blade and arm away
from the glass.
E72899
1
2
2. Press and hold the locking button.
3. Remove the wiper blade.
4. Install in the reverse order.
Note:
Make sure that the wiper blade locks
into place.
REMOVING A HEADLAMP
Contact an authorized dealer.
CHANGING A BULB
Lamp Assembly Condensation
Exterior lamps are vented to
accommodate normal changes in pressure.
Condensation can be a natural occurrence
of this design.
When moist air enters the lamp assembly
through the vents, there is a possibility that
condensation can occur in cold
temperatures.
When normal condensation occurs, a thin
film of mist can form on the interior of the
lens.
The mist eventually clears and exits
through the vents during normal operation.
Clearing time may take as long as 48 hours
under dry weather conditions.
Examples of acceptable condensation are:
•
Presence of thin mist (no streaks, drip
marks or droplets).
•
Fine mist covers less than 50% of the
lens.
Examples of unacceptable moisture
(usually caused by a lamp water leak) are:
•
Water puddle inside the lamp.
•
Large water droplets, drip marks or
streaks present on the interior of the
lens.
Take your vehicle to a dealer for service if
any of the above conditions of
unacceptable moisture are present.
Replacing the Headlamp Bulbs
Note:
Do not touch the bulb glass.
B
A
C
D
E205822
Headlamp assembly:
A. Front parking lamp bulb.
B. High beam headlamp bulb/ Daytime
running lamp bulb.
C. Low beam headlamp bulb.
D. Direction indicator lamp bulb.
240
Ranger (), EB3B-19G219-ZAB enAUS
Maintenance