GENERAL INFORMATION ON
RADIO FREQUENCIES
Note:
Changes or modifications not
expressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
The typical operating range for your
transmitter is approximately 10 m (33 ft).
A decrease in operating range could be
caused by:
•
weather conditions
•
nearby radio towers
•
structures around your vehicle
•
other vehicles parked next to your
vehicle.
The radio frequency used by your remote
control can also be used by other radio
transmitters, for example amateur radios,
medical equipment, wireless headphones,
wireless remote controls, cell phones,
battery chargers and alarm systems. If the
frequencies are jammed, you will not be
able to use your remote control. You can
lock and unlock the doors with the key.
Note:
Make sure your vehicle is locked
before leaving it unattended.
Note:
If you are in range, the remote control
will operate if you press any button
unintentionally.
Note:
The remote control contains sensitive
electrical components. Exposure to moisture
or impact may cause permanent damage.
REMOTE CONTROL
You can program a maximum of eight
remote controls to your vehicle. This
includes any you recieved with your
vehicle. The remote controls must remain
inside your vehicle during the programming
procedure. Fasten the front seatbelts and
close all doors to make sure that
conflicting chimes do not sound during
programming.
Programming a New Remote
Control
Contact an authorized dealer.
Reprogramming the Unlocking
Function
Note:
When you press the unlock button,
either all the doors are unlocked or only the
driver door is unlocked. Pressing the unlock
button again unlocks all the doors.
Press and hold the unlock and lock buttons
on the remote control simultaneously for
at least four seconds with the ignition off.
The direction indicators will flash twice to
indicate a change to the unlocking mode.
To return to the original unlocking function,
repeat the process.
Programming the additional key
Note:
You need to have two programmed
keys for this procedure.
1.
Insert the first key and turn the ignition
on.
2. Remove the key within 10 seconds.
3. Insert the second key within 10 seconds
and turn the ignition on.
4. Remove the key within 10 seconds.
5. Insert the additional key within 10
seconds.
32
Ranger (TKE) Vehicles Built From: 02-05-2016 Vehicles Built Up To: 04-09-2016, EB3B-19G219-AKC enGBR, First Printing
Keys and Remote Controls
Summary of Contents for RANGER 2016
Page 1: ...FORD RANGER Owner s Manual ...
Page 3: ......
