Replacing Key Fob Battery
Remove case back using a small coin or equivalent. Using small screw driver or
similar device, push battery from battery edge so that it slides out from beneath
the battery hold down bracket. DO NOT ATTEMPT TO REMOVE THE BATTERY
HOLD-DOWN BRACKET. Slide in new battery (CR 1632). Snap Key fob case
back together.
Kickstand
Make sure kickstand is in the up position prior to riding the OjO. Do not sit on
your OjO with the kickstand in the down position. Make sure the OjO is stable
before stepping off.
Lights
Your OjO is equipped with state of the art front headlight and rear LED lights.
The headlight and taillight is controlled by the light icon on the display.
The brake light illuminates when the brakes are applied whether lights
are on or off.
Cleaning OjO
A quality automotive soap works best in removing dirt and grime. Avoid
brushes and abrasive scrub pads as they may scratch the finish. Use a soft
sponge or hand towel to wash the body panels. AVOID using high
pressure washers as they may damage wiring harnesses. A battery
pack should NEVER be pressure washed. If you live close to an ocean,
avoid prolonged exposure to ocean spray or salt water. If either comes in
contact with your OjO, wipe down immediately.
Motor
The Patented 500kw HyperGear
©
Motor is completely sealed and requires
no maintenance or lubrication. Keep free of sand and other debris.
Do not ride or submerge in standing water.
Seat
Your OjO seat height is adjustable. Ensure that both feet can easily touch
the ground when setting height. Important: Make sure seat height is set
and the seat clamp is tight before riding the OjO. The OjO scooter is
designed for a single rider only.
19
www.ojoelectric.com
Summary of Contents for OjO electric 500 Series
Page 13: ...13 www ojoelectric com...
