When programming your HomeLink
t
Wireless Control System to
a garage door or gate, be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLink
t
Wireless Control System with any garage
door opener that lacks safety stop and reverse features as required by
U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLink
t
at:
www.homelink.com
or
1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLink
t
equipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelink
t
buttons be erased for security purposes, refer to
Programming
in this section.
Programming
Do not program HomeLink
t
with the vehicle parked in the garage.
Note:
Some vehicles may require the ignition switch to be turned to the
second (or “ACC”) position for programming and/or operation of the
HomeLink
t
. It is also recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLink
t
for
quicker training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons releasing only when the red
light begins to flash after 20
seconds.
Do not
repeat step one to
program additional hand-held
transmitters to the remaining two
HomeLink
t
buttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink
t
.
2. Position the end of your
hand-held transmitter 2–8 cm (1–3
inches) away from the HomeLink
t
button you wish to program (located
on your overhead console) while keeping the red light in view.
Driver Controls
115
