3. Cycle eight times rapidly (within 10 seconds) between the 3 (off)
position and 4 (on).
Note:
The eighth turn must end in the 4 (on)
position.
4. The doors will lock, then unlock, to confirm that the programming
mode has been activated.
5. Within 20 seconds press any button on the remote entry transmitter.
Note:
If more than 20 seconds have passed you will need to start the
procedure over again.
6. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
7. Repeat Steps 4 and 5 to program each additional remote entry
transmitter (up to four transmitters).
8. Turn the ignition to the 3 (off) position after you have finished
programming all of the remote entry transmitters.
9. The doors will lock, then unlock, to confirm that the programming
mode has been exited.
Illuminated entry
The interior lamps illuminate when the remote entry system is used to
unlock the door(s) or sound the personal alarm.
The illuminated entry system will turn off the interior lights if:
•
the ignition switch is turned to the on or accessory position, or
•
the remote transmitter lock control is pressed, or
•
after 25 seconds of illumination.
The dome lamp control (if equipped) must
not
be set to the off position
for the illuminated entry system to operate.
The inside lights will not turn off if:
•
they have been turned on with the dimmer control, or
•
any door is open.
SECURILOCK™ PASSIVE ANTI-THEFT SYSTEM (IF EQUIPPED)
SecuriLock™ passive anti-theft system is an engine immobilization
system. This system is designed to help prevent the engine from being
started unless a
coded key programmed to your vehicle
is used. The
use of the wrong type of coded key may lead to a “no-start” condition.
2009 Econoline
(eco)
Owners Guide, 1st Printing
USA
(fus)
Locks and Security
86
