Black plate (217,1)
3. Detach the electrical connector from
the unit by pulling it to the rear.
4. Install the new side direction indicator
unit.
5. Insert the front end of the unit into the
vehicle and press in the rear end.
NOTE
Bulb replacement is not possible
because it is built into the unit. Replace
the unit.
(LED type)
Due to the complexity and difficulty of
the procedure, the LED bulbs should be
replaced by an expert repairer, we
recommend an Authorised Ford Repairer.
High-mount brake light
í
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Place an index finger into each notch
and pull the high mount brake light
component outward.
3. Press the cover downward to remove it.
4. Remove the screws with a Phillips
screwdriver and then remove the high
mount brake light component.
5. Turn the socket and bulb assembly
anticlockwise and remove it.
6. Disconnect the bulb from the socket.
Maintenance and Care
Owner Maintenance
8-31
í
Some models.
RANGER_F8M1-10-08I_Edition1 Page217
Friday, September 26 2008 3:7 PM
Form No.F8M1-10-08I
