Folding the 20% Middle Seat (iF
equipped) to a load Floor poSition
To fold the seat, pull the lever (lever 3)
located on the seat back to release the
folding seat latch. With the latch released,
the seat back can be lowered into the
load floor position. A moderate force may
be required to move the seat forward
and down.
returning the 20% Middle Seat to
the upright poSition FroM the FullY-loWered Floor poSition
To return the seat to the upright position, lift and pull the seat back until the seat latch is
fully engaged.
quick reference guide
EXPEDITION
07
QUICK REFERENCE GUIDE
EssENTIal
INfOrmaTION
Fuel tank CapaCitY
Your vehicle’s fuel tank can accommodate 28 gallons (106L) of gasoline.
(expedition eL accomodates 33.5 gallons (126.8L) of gasoline.) Your vehicle is designed to use
“regular” unleaded gasoline with a pump (r+M)/2 octane rating of 87 for optimum performance.
The use of gasoline with lower octane ratings may degrade performance.
tire preSSure
Your tire pressure is properly set at the dealership according to the recommended
specifications found on the certification Label located on the front door latch pillar on the driver’s
side. Please check your tire pressure during routine maintenance and seasonal changes and when
the Tire Pressure Monitoring System warning indicator (if equipped) is illuminated. Warning: im-
properly inflated tires can affect vehicle handling and tire performance. See “Additional features” on
the reverse side for more information.
FuSeS
if electrical components in the vehicle are not working, a fuse may have blown. for more infor-
mation about changing a fuse, please consult your Owner’s guide.
Fuel puMp Shut-oFF SWitCh
After a collision, if the engine cranks but does not start, the fuel pump
shut-off switch may have to be reset. The switch is located in the left rear quarter trim panel, near
the liftgate, behind an access panel. for complete details on resetting the switch, please consult your
Owner’s guide.
Changing the tireS
if you get a flat tire while driving, do not apply the brake heavily. instead, gradu-
ally decrease your speed. Hold the steering wheel firmly and slowly move to a safe place on the side
of the road. Prior to jacking, hoisting or towing your vehicle, be sure to turn Off the running boards (if
equipped), and the air suspension switch. Your vehicle may be equipped with a conventional spare tire
that is different in one or more of the following: type, brand, size, speed rating and tread design. Your
vehicle may be equipped with a spare wheel that may not match the road wheels and is not equipped
with a Tire Pressure Monitor System (TPMS) Sensor.
Location of the Spare tire and tooLS
item
Location
Spare Tire
under the vehicle, just forward of the rear bumper
Jack Tools and
under the access panel, located in the floor compartment behind the
Jacking instructions
third row seat
roadSide eMergenCieS
To fully assist you if you should have a vehicle concern, ford Motor com-
pany offers a complimentary roadside assistance program. This program is separate from the new
Vehicle Limited Warranty. The service is available 24 hours a day, seven days a week for the new Ve-
hicle Limited Warranty period (u.S.) or Basic Warranty period (canada) of three years or 36,000 miles
(60,000 km). roadside assistance will cover:
q
changing a flat tire
q
Jump-starts
q
Limited fuel delivery
q
Lockout assistance
q
Towing of your vehicle
q
Winch Out
roadSide aSSiStance centerS
country
Phone number
united States
1-800-241-3673
canada
1-800-665-2006
for complete details on any roadside assistance concern, please consult the roadside emergencies
chapter, or the customer Assistance chapter in your Owner’s guide.
ford Motor company customer relationship center
P.O. Box 6248
dearborn, Mi 48121
1-800-392-3673 (fOrd)
(Tdd for the hearing impaired: 1-800-232-5952)
7L1J-19g217-AA
7L1J19G217AA
June 2006
first Printing
quick reference guide
expedition
Litho in u.S.A.
1
4
7
aUDIO sYsTEm
PreMiuM/AudiOPHiLe AM/fM STereO in-dASH Six cd/MP3 SOund SYSTeM (if equipped)
sECOND rOW sEaTs
sECOND rOW sEaTs
(cOnTinued)
This quick reference guide is not intended
to replace your vehicle Owner’s guide which
contains more detailed information concerning
the features of your vehicle, as well as important
safety warnings designed to help reduce the risk
of injury to you and your occupants. Please read
your entire Owner’s guide carefully as you begin
learning about your new vehicle and refer to the
appropriate chapters when questions arise.
All information contained in this quick reference
guide was accurate at the time of duplication. We
reserve the right to change features, operation
and/or functionality of any vehicle specification
at any time. Your ford dealer is the best source
for the most current information. for detailed
operating and safety information, please consult
your Owner’s guide.
iMPOrTAnT: Before folding the second row seats, ensure that the head restraints are fully flipped
down by pulling on the strap and that all items have been removed from the floor and off the seats.
.
exiting the third roW Seat
fold head restraint forward
(Pos. 4)
. Pull up on the strap located at the back of the second row seat
by the outboard side shield
(Pull Strap)
. The seat back will fold forward to the cushion
(Pos. 5)
.
continue pulling up on the pull strap and the seat will flip forward
(Pos. 6)
. To return the seat to the
upright position, push the seat down until it is latched to the floor strikers. Then, lift the seat back to
the upright position and flip the head restraint to the upright position.
Folding the outboard Seat baCkS
to a load Floor poSition – (reFer
to the iMportant note above)
To fold the seats to a load floor position,
lift the lever
(Lever 1)
located on the
outboard side of the seat to release the
seat back. To lower the seat further to
the fully-lowered position for maximum
cargo capacity, locate
(Lever 2)
on the
seat back. releasing the lever releases
the seat into the kneel-down floor
position. A moderate force may be required to move the seat forward and down.
POWEr lIfTGaTE OPEraTION
returning the SeatS to the upright poSition FroM the
FullY-loWered Floor poSition
The seat back cannot be returned to the upright position until the seat
is returned from the kneel-down position. To return the seat to the
upright position, lift and pull the seat rearward until the latch is fully
engaged. do not attempt to unlatch the rear floor hooks while the seat
is in the kneel-down position.
With the seat back in the folded down position, lift up on the seat back.
This will allow the seat back to be lifted to the upright locked position.
To open the optional power liftgate, push the button on the
instrument panel
(Figure A)
, or press and release the con-
trol located in the left rear quarter panel
(Figure B)
. keep
clear of the liftgate when operating the rear switch.
To open the liftgate manually, place your hand on top of the
liftgate handle
(Figure C)
and pull. do not pull the handle
from the bottom. To close, make certain the liftgate glass
is closed, and then push the liftgate closed until it latches
securely.
To unlatch the liftgate glass, push the button
(Figure D)
under the center of the license plate lamp shield. Pressing
on your keyfob will also unlatch the liftgate glass.
do not open the liftgate or the liftgate glass in a garage or
other enclosed area with a low ceiling.
A
c
1
Cd eJeCt
Press and a
memory preset 1-6 to eject a
cd from a specific slot. Press
and hold to auto eject all cds
present in the system.
2
load
Press LOAd and a
memory preset to load a
specific slot. Press and hold to
autoload up to six cds.
3
aM/FM
Press to select AM/
fM1/fM2 frequency band.
4
Seek
Press to access the
previous or next strong station,
cd track, previous/next chan-
nel (if equipped with satellite
radio), previous/additional
display text or category.
5
text/SCan
Press and hold
to hear a brief sampling of ra-
dio stations or cd tracks. Press
again to stop. in cd/MP3
mode, press and release to
display track title, artist name
and disc title.
6
Folder
in folder mode,
press to access previous or
next folder on MP3 discs,
if available.
Satellite radio FeatureS
and ControlS (if equipped)
7
aux
Press repeatedly to cycle
through feS/dVd (if equipped),
SAT1, SAT2, SAT3 (satellite
radio mode if equipped),
Line in (auxiliary audio mode
if equipped) or feS/dVd (if
equipped). Once Satellite radio
mode is activated you may use
the following functions:
Press Menu until cATegOrY
MOde appears in the display.
Press / to scroll through
the list of SiriuS channel cat-
egories. Press Seek to select.
Press ScAn to hear a brief
sampling of channels in the
selected category.
Press Seek to access the previ-
ous/next channels. Press and
release TexT/ScAn to display
the current song title. Press
again to scroll through current
song title, artist, channel
category and the SiriuS long
channel name. Press and hold
for a brief sampling of the next
channels. Press again to stop.
8
tune/diSC SeleCtor
in radio mode, press to go
up/down the frequency band in
individual increments.
9
Menu
Press repeatedly to
cycle through the following
modes: category (if equipped
with satellite radio), Setting the
clock, Autoset, rBdS On/Off,
Treble, Bass, Balance, fade,
SPeedVOL (Speed Sensitive
Volume, if equipped), ALL
SeATS (Occupancy Mode),
Track/folder, and compres-
sion. for more information,
please consult your Owner’s
guide.
10
Setting MeMorY pre-
SetS
Select AM, fM1 or fM2
band, then tune to a station.
next, press and hold a num-
bered preset button until the
sound returns.
Setting the CloCk
Press
Menu until SeLecT HOur or
SeLecT MinS is displayed.
Press up/down arrows/<Seek>
to adjust the hours/minutes.
2
3
6
5
8 9 10
d
B
entering the third roW Seat
fold head restraint forward
(Pos. 1)
. Pull up on the lever
(Lever 1)
located on the side of either out-
board second row seat until the seat back folds forward to the cushion
(Pos. 2)
. Pull lever fully upward
(Lever 1)
. The seat will then flip forward
(Pos. 3)
.
Pos. 1
Lever 1
Pos. 2
Pos. 3
Pos. 4
Pull Strap
Pos. 5
Pos. 6
