303-08B-217
Engine Emission Control — Diesel Engine
303-08B-217
REMOVAL AND INSTALLATION
E6362 EN
09/2001 2002 Bantam
Exhaust Manifold to Exhaust Gas Re-circulation (EGR) Valve Tube (23 301 0)
Removal
1. Remove the exhaust gas re-circulation
valve.
Refer to procedure contained in this section.
2.
CAUTION: When removing the exhaust
manifold to exhaust gas re-
circulation pipe from the exhaust
manifold, make sure that the sealing
ring comes away with the pipe and
does not fall into the exhaust
manifold.
Remove the exhaust manifold to exhaust
gas re-circulation valve pipe (one bolt).
Installation
1. Remove and discard the two exhaust
manifold to exhaust gas re-circulation valve
pipe sealing rings.
2. Examine the exhaust manifold to exhaust
gas re-circulation pipe for corrosion and
carbon deposits. Clean as required.
3. Renew the two exhaust manifold to exhaust
gas Re-circulation valve pipe sealing rings.
4. NOTE:
When cleaning is required, take care
not to allow debris to fall into the exhaust
manifold or exhaust gas re-circulation valve.
Examine the exhaust manifold and exhaust
gas re-circulation valve orifices for signs of
corrosion and carbon deposits. Clean as
required.
5. Refit the components in reverse order.