100-00-6
General Information
100-00-6
DESCRIPTION AND OPERATION (
CONTINUED
)
E849 EN
06/2001 2002 Bantam
Inspection and Verification
Visual Inspection Charts, Symptom Charts and other
information charts (such as diagnostic routines),
supplement test procedures with technical
specifications, or navigate the user to a specific test
procedure.
Sympton Chart
The symptom chart indicates symptoms, sources and
actions to address a condition.
Pinpoint Tests
For electrical systems, pinpoint test steps are used to
identify the source of a concern in a logical, step-by-
step manner. Pinpoint tests have two columns:
CONDITIONS and DETAILS/RESULTS/ACTIONS.
The CONDITIONS column is used exclusively for
graphics and icons (with or without captions) and the
DETAILS/RESULTS/ACTIONS column provides
direction to another test step or specific corrective
actions.
The boxed numbers indicate the order in which the
described action is to be performed.
Component Tests
A component test is used when a component is tested
in multiple pinpoint tests, or if a procedure is too
complicated to be formatted within a single page of the
pinpoint test.
Graphics
Test graphics show the measurement or test to be
performed in a test step.
A representative tester graphic is used for voltmeters
and ohmmeters.
If multiple measurements are made in a single
graphic, the test leads are drawn with a solid line until
the test lead splits to indicate the multiple
measurements, at which point dashed lines are used.
Breakout box-type testers are represented by a double
circle test pin. Test pins are labelled with the pin
number.
Samples
Special Tools and Torque Figures
Any requirement for special tools will picture the tool,
showing it in use and with its tool number shown.
Torque settings will be given at the relevant point in
the procedure.
FORD BANTAM
