501-14-19
Handles, Locks, Latches and Entry Systems
501-14-19
DISASSEMBLY AND ASSEMBLY
E6385 EN
08/2001 2002 Bantam
Door Lock Cylinder
Material
Specification
Lock barrel grease
WSS-M1C253-A
Disassembly
1. NOTE:
Determine the key code of the lock
either by examining the key, key cutting kit
instructions, the customers service records or
by dismantling the lock and examining the
numbers stamped on each number.
Alternatively, identify the tumblers (by reading
the notches on each tumbler edge) and make
a note of the key code.
Read the key code.
• The key code can be read as follows:
• 1 notch = 1, 2 notches = 2, 3 notches = 3
and 0 notches =4
Assembly
1. NOTE:
The first tumbler inserted into the
tumbler magazine should be the last number
of the key code. This should be followed by
the spring washer.
Arrange the tumblers, spring washer and
the spacers to enter the tumbler magazine.
1. Tumblers.
2. Spring washer.
3. Spacers.
2. Install the tumblers and the spacers so that
their grooves are aligned with the cutout
slot in the side of the tumbler magazine.
3. Pack the tumbler magazine with lock barrel
grease.
