Ford 2002 Bantam, Workshop Manual

Page: 1445 / 1663

501-09-2 Rear View Mirrors 501-09-2
DIAGNOSIS AND TESTING
Rear View Mirrors
Refer to Wiring Diagrams
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical and electrical damage.
Visual Inspection Chart
Mechanical Electrical
Exterior mirror(s) Fuse(s)
Mechanical Electrical
Relay
Electrical connector(s)
Switch
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Condition Possible Sources Action
• The mirrors are inoperative • Exterior mirror control switch. • CARRY OUT the Exterior Mirror
Control Switch Component Test.
REFER to the Wiring Diagrams.
• Circuit(s). • Go To Pinpoint Test A
• A single mirror is inoperative • Exterior mirror control switch. • CARRY OUT the Exterior Mirror
Control Switch Component Test.
REFER to the Wiring Diagrams.
• Circuit(s).
• Exterior mirror motor(s).
• Go To Pinpoint Test B
• A single mirror does not function
with switch logic
• Exterior mirror control switch. • CARRY OUT the Exterior Mirror
Control Switch Component Test.
REFER to the Wiring Diagrams.
• Circuit(s).
• Exterior mirror motor(s).
• Go To Pinpoint Test C
Pinpoint Test
NOTE: Use a digital multimeter for all electrical
measurements.
07/2001 2002 Bantam
Cell: 50109, Rear View Mirrors
for schematic and connector information.