206-09-10
206-09-10
Anti-Lock Control
DIAGNOSIS AND TESTING (Continued)
PINPOINT TEST D: DTCs C1233, C1234, C1235, AND C1236, WHEEL SPEED — INPUT SIGNAL MISSING
TEST STEP
ACTION TO TAKE
Yes =
REPLACE the tone ring.
•
CAUTION: Examine the tone ring carefully with good light.
Failure to catch issues with the tone ring will lead to unnecessary
component replacement.
Inspect the tone ring for corrosion, nicks, missing teeth, or other obvious
damage.
•
Is the tone ring damaged?
No =
GO to D3.
D3 CHECK AIR GAP AT ANTI-LOCK BRAKE SENSOR
•
Measure the air gap between the anti-lock brake sensor and the tone ring
Yes =
REPLACE the anti-lock
teeth. Repeat in at least two more wheel positions. Verify the value as
brake sensor.
indicated below:
Front Anti-Lock Brake Sensors
No =
REPLACE the tone ring.
— 0.43 mm (0.017 in) to 1.85 mm (0.073 in)
Rear Anti-Lock Brake Sensors
— 0.097 mm (0.004 in) to 1.62 mm (0.064 in)
•
Is the air gap correct and consistent for all wheel positions?
PINPOINT TEST E: DTC B1676 BATTERY VOLTAGE OUT OF RANGE
TEST STEP
ACTION TO TAKE
E1 CHECK FUSE AND POWER TO ANTI-LOCK BRAKE CONTROL
MODULE
•
CAUTION: If the malfunction indicator lamp (MIL) is
illuminated, retrieve diagnostic trouble codes (DTCs) from the
Interface Adapter Assembly (IAA) module before carrying out this
pinpoint test. If IAA module DTCs exist, refer to the Interface
Adapter Assembly (IAA) Module Diagnostic Trouble Code (DTC)
Index in Section 100-07. Failure to follow this caution may lead to
misdiagnosis and unnecessary component replacement.
Check the MIL before proceeding.
•
Check 30A fuse 3 in the electric vehicle power distribution box
Yes =
GO to E2.
(EVPDB).
•
With key OFF, disconnect anti-lock brake control module C154.
No =
REPAIR as necessary.
•
With key ON, measure the voltage between pin 25 (R wire) on the
anti-lock brake control module C154 and ground. (V > 10 volts)
•
Is everything OK?
E2 VERIFY CONCERN IS RESOLVED
•
Reconnect anti-lock brake control module C154.
Yes =
REPLACE the Anti-lock
•
Clear the ABS DTCs.
Braking System
(ABS)/Hydraulic Control
Unit (HCV) assembly.
•
Retrieve ABS DTCs.
No =
Concern is intermittent.
•
Does the same DTC occur?
INSPECT all connections
for corrosion, pin pushout,
and terminal contact.
REPAIR as necessary.
2001 Ranger EV, 01/2001
Summary of Contents for 2001 Ranger
