Forcepoint V10000, Appliance Upgrade Manual

Page: 76 / 90

Upgrading V-Series Appliances
72

Upgrading V-Series Appliances
This upgrade process applies to the following platforms and TRITON solutions:
● V10000 and V5000 appliances . For a list of supported models, see V-Series
appliances supported with v8.x .
● TRITON AP-WEB and Web Filter & Security, v8.0 and higher
● Web Security, and Web Security Gateway / Anywhere, v7.8.4
● TRITON AP-EMAIL, v8.0 and higher
● Email Security Gateway / Anywhere, v7.8.4
If you are upgrading TRITON APX (multiple TRITON solutions), see Upgrading to
TRITON APX v8.3 .
If you are upgrading TRITON AP-DATA, see Upgrading to TRITON AP-DATA
v8.3.x .
Following is a list of upgrade paths to v8.3.x. You must upgrade to v7.8.4 (or higher)
before upgrading to v8.3.x:
The upgrade is applied with a software patch and is initiated in the Appliance
Manager on the
Administration > Patches/Hotfixes > Patches page. The upgrade
procedure ends with some tasks performed in the TRITON Appliances command-line
interface (CLI). Accessing the CLI is unchanged from past versions. If you’re
Important
In this upgrade, the V-Series Appliance Manager is
replaced with the TRITON Appliance command-line
interface (CLI).
(The new TRITON Appliance Manager
is coming in 2017.)
The upgrade process begins in the Appliance Manager, as
usual, and ends in the CLI to perform several post-upgrade
activities.
For an introduction to the CLI, see V-Series Appliances:
Visual Primer for the v8.3 Appliance CLI .
To
upgrade
from
To this
version
Step One Step Two Step Three Step Four
7.8.4, 8.0.x,
8.1.x, 8.2.x 8.3.x Upgrade to
8.3.x
7.8.1, 7.8.2,
7.8.3
8.3.x Upgrade to
7.8.4
Upgrade to
8.3.x
7.7.x 8.3.x Apply HF
90
Upgrade to
7.8.1
Upgrade to
7.8.4
Upgrade to
8.3.x