3.
setting up the sigma.7
This section describes the steps to follow to setup your sigma.7 device before use.
IMPORTANT
PLEASE KEEP THE ORIGINAL PACKAGING
ONLY USE THE ORIGINAL PACKAGING FOR STORING OR SHIPPING
3.1
device installation
The sigma.7 haptic device is shipped in 3 boxes. Please start by opening the 2 smaller boxes
which contain the device stand. The operations described below are best performed by a team of
2 people.
9 screws and a corresponding orange hex-driver tool are provided in the packaging.
Each one of the 3 legs is mounted on the pole by securely fastening 3 screws, as shown in figure
2. Make sure that the legs are laid out as shown in figure 3, so that the rubber feet of the lower 2
legs on this figure are located near the lower leg borders. The rear leg of the stand is recognized
with the rubber foot being located at its centered position.
figure 2 – mounting of the device stand legs onto the pole
8
