FOR-A VSF-128128, Operation Manual

Page: 25 / 106

13
4. Internal Settings
Depending on your system configuration, settings for Dip switches and jumpers on the internal
MAIN board may have to be changed from factory defaults.
IMPORTANT
Always switch unit power OFF and disconnect power cord before accessing unit
interior to make settings.
1) Remove the two screws on the front panel of VSF-600.
2) For the details of individual card settings, see section 4-1 to 4-3. The card in slot 13 needs to be
taken out from the slot by using injector to verify the settings. The cards in other slots can be
observed as they are in slots.
3) After completing verification and modification of settings, attach and secure the front panel with
two screws.
ON
OFF
Slot 1-2 (VSF-I3204)
（ See section 4-1 ）
Slot 3-10 (VSF-X6432)
（
See section 4-2
）
Slot 13 (CPU)
(See section 4-3)
Slot1 1-12 (VSF-I3204)
（
See section 4-1
）