66
6. Crosspoint Control
6-1. Single Crosspoint Switching
There are two ways of switching crosspoints: Switching a crosspoint one at a time, or switching
multiple crosspoints simultaneously. This section describes the switching of a single crosspoint.
6-1-1. Single Crosspoint Switching by X-Y Setting
A crosspoint can be switched using destination and source buttons on the remote control unit.
Destination and source channels must be assigned to those buttons beforehand.
(Ex.)
The following procedure outputs source channel 8 to destination channel 4.
Step
Description
Indications
1
Press a destination button to
select destination channel 4.
- The selected destination button lights up.
- The button with the destination channel
indication is highlighted.
- Menu display appears as shown below.
2
Press a source button to select
source channel 8.
- The selected source button lights up.
- The button with the source channel indication
is highlighted.
Destination and source channels can also be selected using
CONTROL
or the display.
To select channels via
CONTROL
, the mode menu must be set to destination mode or
source mode using the
MODE
button(s). (Supported for MFR-18RU/18RUA/
39RU/39RUA/16RUTA/8RUA)
Operation using the display is available only on MFR-16RUD.
MFR-18RU/18RUA/39RUA/16RUTA/8RUA units have the Control DestMode function,
which can be set in the [Web-Based Control: RU Settings page]. If
Control DestMode
is
set to
Crosspoint
, crosspoints can be switched by turning
CONTROL
after
simultaneously pressing a destination button and
CONTROL
.
► See Sec. 5-2-4. “Operating with CONTROL (Rotary Selector)” for details.
Control Assist Buttons
The following functions are available using remote control unit buttons that assist
crosspoint switches.
► See Sec. 6-1-1-1 "SKIP-FWD/SKIP BWD" for SKIP-FWD and SKIP-BWD
► See Sec. 6-1-1-2 "TENKEY" for -TENKEY
DST : 4 [DST4
]
LVL : 0001 [Level-1
]
