11
2-2. Rear Panel
(1) VIDEO IN
Used to input analog composite video signal.
(2) VIDEO OUT 1/2
Used to output analog composite video signal. VIDEO OUT1 outputs the corrected signal of
the input video in VIDEO IN if the OPERATE/BY-PASS switch is set to OPERATE (down).
VIDEO OUT1 outputs the input video in VIDEO IN without correction if the OPERATE/
BY-PASS switch is set to BY-PASS (up) or the unit is turned off.
VIDEO OUT2 outputs the corrected signal of the input video regardless of the OPERATE/
BY-PASS switch setting. It does not output any signal if the unit is turned off.
VIDEO OUT
Power ON/OFF
OPERATE / BY-PASS switch
Output video
1
ON
OPERATE Corrected
video
BY-PASS
Input video
(uncorrected)
OFF ---
Input video
(uncorrected)
2
ON OPERATE
／
BY-PASS Corrected
video
OFF ---
None
(3) REMOTE
Used for remote control. 9-pin D-sub female. See section 7-1 “Remote Connector” for details.
(4) LAN
Used for remote control via a LAN (Ethernet) interface.
For details on control via a web browser, see section 8 “Remote Control via Web Browser”.
For details on control using LAN commands, see the separate IVS-200 LAN Command
Operation Manual.
(5) Cooling fan
Used to air cool the unit to prevent overheating. Do not block the air vents at the back of the
unit with other equipment or objects.
(6) DC12V IN
Used to connect the unit to an DC power source using a separately purchased AC adapter.
1
2
DC 12V IN
SE
R
.
N
O
.
VIDEO OUT
VIDEO IN
LAN
REMOTE
(1)
(2)
(3)
(5)
(6)
(4)
