75
8-5. KEY Transitions
Key images are displayed on each M/E output screen. This chapter explains how to perform key
transitions using M/E1KEY1 as an example.
(1) Perform key setup for the KEY. (See section 10. "KEY.")
(2) Perform a desired transition referring to the below procedures.
CUT Transition
<Method 1>
(1) Press KEY1 in the NEXT TRANSITION block.
(2) Press CUT to perform a key CUT transition.
<Method 2>
(1) Press KEY1 ON AIR to insert KEY1 onto the M/E1 program video. Press the button again to
remove KEY1 from the screen. (See section 8-9. " Key IN/OUT Effects" for details.)
MIX Transition
(1) Press KEY1 in the NEXT TRANSITION block.
(2) Press MIX in the TRANSITION TYPE block.
(3) Press AUTO or KEY1 AUTO, or move the fader lever to perform the KEY1 MIX transition.
The KEY1 AUTO button behaves the same as the AUTO button when selecting KEY1 for
the next transition. For example, if MIX is set as the KEY1 transition type under the NEXT
TRANSITION, the KEY1 mix transition is performed when KEY1 AUTO is pressed and a
KEY1 wipe transition is performed if WIPE is set as the transition type.
REV
NOR/REV
PATTERN
BKGD
DIRECTION
KEY1
KEY2
KEY3
KEY4
NEXT TRANSITION
FASER LIMIT
MIX
WIPE
TRANSITION TYPE
AUTO
CUT
ON AIR
DVE
DVE
KEY 4
KEY 3
KEY 2
DVE
KEY 1
DVE
REV
NOR/REV
PATTERN
BKGD
DIRECTION
KEY1
KEY2
KEY3
KEY4
NEXT TRANSITION
FASER LIMIT
MIX
WIPE
TRANSITION TYPE
AUTO
CUT
ON AIR
DVE
DVE
KEY 4
KEY 3
KEY 2
DVE
KEY 1
DVE
