57
6-3. Preview Set Up
The switcher does not have a dedicated PREVIEW output. The preview bus output can be
assigned to, however, an SDI OUTPUT or AUX output. Users can also add the key images to
PREVIEW. This can be done as explained below:
6-3-1. Preview Bus Monitoring
Follow the procedure below to assign the preview video to an AUX output. AUX1 is used in
the example below.
(1) Quickly press AUX1 twice in the BUS SELECT block to display the [SETUP - OUTPUT -
OUT XPT] (1/4) menu.
(2) Turn F1 to select AUX1.
(3) Turn F2 to select M1PV.
OUTPUT :SELECT : XPT :INHIBIT:AUX TRS: 1/4
OUT XPT : =
AUX1
: =
M1PV
: =OFF : =OFF :
6-3-2. Setting Up Preview Images
(1) Open PAGE 3 or PAGE 4 in the [SETUP - OUTPUT - CLN/PREV] menu.
(2) Turn F1 to F4 to set whether the key images are to be displayed on the preview image,
then press the push-button to confirm the setting for each.
OUTPUT : KEY1 : KEY2 : KEY3 : KEY4 : 3/4
M/E1 PRV: =
ON
: =
ON
: =
OFF
: =
OFF
:
OUTPUT : KEY1 : KEY2 : KEY3 : KEY4 : 4/4
M/E2 PRV: =
ON
: =
ON
: =
OFF
: =
OFF
:
Item
Setting
NEXT TRANSITION
KEY
On-Air/Off-Air
KEY image on
PREVIEW
PREVIEW
OUT -
KEY1-4
ON
KEY button ON
On-Air
Not displayed
ON
KEY button OFF
On-Air
Displayed
ON
KEY button ON
Off-Air
Displayed
ON
KEY button OFF
Off-Air
Not displayed
OFF ---
---
Not
displayed
Whether the KEY images are displayed on the preview depends on both the PREVIEW OUT
settings and KEY button status in the NEXT TRANSITION section.
