227
30-2-2. Assigning Actions to AUX Unit Buttons
Assigning actions to AUX unit buttons should be performed in the switcher menu.
Ex.) To "Output the PGM signal from the AUX3 bus on UNIT 1:
There are two ways to perform this action.
Assign
"
AUX3 XPT M/E1 PGM
" to a button and press the button.
Assign
"
AUX3 bus
" to a button and "
PGM signal
" to another button, then press these
buttons.
If Using Only a Single AUX Unit Button:
(1) Open [SETUP - EXT I/F - AUX UNIT] menu PAGE 1.
(2) Select
UNIT1
under
SELECT
. Note that the total number of buttons are displayed in
parentheses.
AUX UNIT: SELECT : AUX SEL: : 1/5
SELECT : =
UNIT1[xxBTN]
: =AUX1 : :
(3) Open [SETUP - EXT I/F - AUX UNIT] menu PAGE 4.
(4) Set the menu as shown below.
AUX UNIT: SELECT: TYPE : FUNC(F3) : 4/5
PANEL : =
1
: =
AUX3
:=
AUX3 XPT M/E1 PGM
(5) Press Button 1 on UNIT 1. The AUX 3 output signal is changed to PGM.
If Using Two AUX Unit Buttons:
(1) Select UNIT 1 on PAGE 1 in the same way as above.
(2)Set as shown below for Button 1 in [SETUP - EXT I/F - AUX UNIT] menu PAGE 4.
AUX UNIT: SELECT: TYPE : FUNC(F3) : 4/5
PANEL : =
1
: =
AUX
:=
AUX3 XPT SELECT
(3) Set the menu as shown below for Button 2.
AUX UNIT: SELECT: TYPE : FUNC(F3) : 4/5
PANEL : =
2
: =
AUX
:=
AUX XPT M/E1 PGM
(4) Press Button 1 then Button 2 on UNIT 1. The AUX 3 output signal is changed to PGM.
AUX ID Number
Button number
Action type (See the
table in the next page.)
Action (See the table in
the next page.)
