FOR-A HVS-350HS, Operation Manual, Page: 150 / 266

136
18-1-7. Editing Sequences: Setting Interpolation and Duration
This section explains how to set the interpolation mode and the playback time using KEY1 as
an example.
Smoothing Movements for KEY1 (Interpolation Mode)
At factory default settings, the movements between steps in the background, KEY, DSK and
PinP are linearly interpolated.
LINE(linear) SMOOTH(curve) CUT
(1) Open PAGE3 in the [SEQ EDIT] menu.
(2) Select KEY1 at
SELECT
.
(3) Select SMOOTH at INTERP (interpolation).
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =
KEY1 : =OFF : =AUTO : = SMOOT :
Note that the transitions between the last step and the first step are performed by CUT
during loop play. Therefore, the transitions between them look smoother when using the
same data for the first and last steps.
Changing Playback Time
At factory default setting, the time intervals between steps are automatically set to 30 frames
(for 60Hz signals) or 25 frames (for 50Hz signals).
(1) Display the [SEQ EDIT] menu. In the menu examples below the
TOTAL-D
(total duration)
value is 120 on PAGE 1 and the
DUR
(duration) for Step1 is 30 on PAGE 2.
SEQ EDIT: LOOP : DIR : LINK :TOTAL-D: 1/3
PLAY : =ON : =NORML: =OFF : =
120 :
SEQ EDIT: STEP : DUR : BREAK :BRK CTL: 2/3
STEP : =
1 : = 30 : =ON : =OFF :
(2) For example, change the duration for Step4 to 60 (frames). The total duration of the
sequence must be 150 (the sum of each step's duration).
When changing
TOTAL-D
to 200, the duration time of each step automatically increases
while keeping the ratios the same. The values for DUR in the menu, however, are not
changed. In this case, they represent not the real values but the relative values (ratios).
DUR
：
30
TOTAL DURATION ： 150
DUR
：
30 DUR
：
30 DUR
：
60