FOR-A HVS-350HS, Operation Manual, Page: 133 / 266

119
17. Event Memory
The switcher can save control panel setup statuses as data for recall when needed. This function is
called Event Memory. This Event Memory function enables quick recall of the same setting statuses
that were previously saved. The event memory data can accurately reproduce statuses of KEY,
DSK and PinP and button assignments for P/P, M/E and KEY/AUX buses including a re-entry of
M/E PGM on the control panel, because the event memory data holds all panel information.
The keypad is used to save and recall events. The event memory data can be saved and recalled
from USB flash memories. For details, see section 19 "File Operations."
In addition to this, the RATE item in the EVENT menu allows users to perform transitions by loading
events.
17-1. Storing Events
The event memory can store the setting status of the control panel. Up to 100 events (10
memory pages, with10 events per page) can be stored in memory.
To Store an Event (basic):
(1) Press the EVENT memory button.
(2) Press STORE (ENTER) on the Keypad.
(3) Press a number button (0-9) on the Keypad
to store the event.
Storing Events (detailed):
(1) Press the EVENT memory button.
The [EVENT MEMORY] menu is displayed
and the Keypad switches to EVENT mode.
(2) Turn F1 to select an event page in the [EVENT MEMORY] menu. PAGE 0 has Event 0-9
(event memories), PAGE 1 has Event 10-19, and so on. The last page, PAGE 9 has Event
90-99.
EVENT : PAGE :DIRECT :PAGECLR:RATE : 1/3
MEMORY : =0 : =OFF : =OFF : =OFF : L=0
(3) Press STORE (ENTER) on the Keypad. The STORE button lights up green and the [EVENT
STORE] menu will then be displayed.
(4) The [EVENT STORE] and [EVENT MEMORY] menus allow users to select the data to be
saved in the event. (See the next page for details.)
(5) Press a number button (0-9) on the Keypad to store the event.
If an Event is Already Saved to a Button:
When STORE is pressed, the light of the buttons (0 to 9) are off if no events are saved. The
number buttons light up if events are saved. If you press a button where an event is already
saved, it flashes. Pressing the button again overwrites the event. If you press another button
that has no event already saved before overwriting, the event will be saved to that button.
If you cannot overwrite data, change
OVER WR
to ENABL (ENABLE) in the [EVENT-
RECALL] menu. (See section 17-3. "Overwrite Protection".)
Data not saved in the event memory
All SETUP menu settings
All FILE menu settings
STILL images
USER TRANS and ADV CTRL settings in the TRANS menu
SELECT / KEYPAD
MEMORY
CONTROL
WIPE
MENU
INC
DEC
+/-
PLAY
STOP
CLEAR
2D DVE
USER BUTTON
7
4
1
CUT
0
COPY
EVENT
COPY/SWAP
8
SWAP COPY
5
RECALL
PASTE
SEQUENCE
SEQ EDIT
9
NEW
6
INS
3
ADD
STORE
ENTER
OVWR
SETUP STILL MATT FILE
KEY1 KEY2 P IN P1 P IN P2
DSK1 DSK2 DSK3 DSK4
WIPE
2
DEL